If you own a smartphone, you’ve experienced at least one heart-stopping moment when your Phone sank into a puddle or was the victim of an accidental splash. Unfortunately, these electronic devices have a design that is not friendly to moisture, so that moisture can harm your device.
How Does Water Get inside Your Phone?
Every mobile device includes apertures and ports via which water (as well as dust and sand) might enter if you’re not careful. The headphone jack, speakers, microphone, and charging port are all included. Some handsets include setting dock covers. However, this does not make them waterproof. So keep these apertures and ports covered if you’re walking through the rain or in a splash zone.
What Happens When Water Goes Into Your Phone
Water usually causes the most harm once it has invaded your Phone when it reaches the inside circuitry. So turn your Phone off and remove the replaceable battery and SIM card to shut the power off before water can enter your Phone’s circuitry. It’s critical not to shake your Phone or use a hairdryer to force the water out at this point because it could cause more damage by scorching it or pushing the water deeper inside.
Water Can Damage the Performance of Your Phone’s Speakers
If you drop your Phone in water, it will break the speaker’s performance and also make it difficult for you to hear calls.
Moisture can Harm the Appearance of Mobile Screen
When water enters the Phone, it can harm your mobile screen or disable your mobile phone repair touch performance. In addition, moisture can slowly penetrate your device permanently.
Water Can Cause Corrosion inside your Phone
Water can cause rust on the interior of your Phone. However, this harm will not become visible overnight.
Inside every gadget, copper traces (wired connections between your device’s components) transmit the electrical currents that power your phones, tablets, smartwatches, and other devices. When you expose those devices to an electrolyte-containing liquid, an instant flow of electricity begins between the traces. This erodes the original traces or creates new damages that should not exist. The wear is caused by removing copper oxide, which appears as a green build-up that can slowly damage your Phone.
How Can you Save your Device from Moisture
Step 1: Switch it Off as soon as possible
Please don’t assume that it isn’t damaged because your device is still operational. Water is filthy in this way. By turning it off, you limit the possibility of an electrical short circuit irreversibly damaging your smartphone.
If the Phone is already turned off, leave it alone. Don’t try to power it up, charge it, or do anything else until you’ve completed the drying process.
Step 2: Remove your Device Case
There could be liquid trapped inside your case, underneath a screen protector. Remove the screen protector off your device and remove it from its case.
Step 3: Dry it Out
To dry the outside of your device, use anything you have on hand: a towel, paper towel, t-shirt, etc. Shake as much liquid as you can out of the device.
Step 4: Use Silica Gel
Silica gel is a desiccant, which means it absorbs moisture and dries the air surrounding it. You’ve probably seen silica gel in little packets labelled “Do Not Eat!” People frequently ship them clothes, electronics, and even meals.
After thoroughly drying the outside of your device, it’s time to introduce silica gel packets to finish the job. Put your device in an airtight container with many silica gel packets. Use enough silica gel to absorb all of the liquid within your device. It’s tough to say how much silica gel to use, but it’s better to use too much than not enough.
Step 5: Bring your Phone to the Professional
Dealing with electronics in water is a complex and frustrating operation. In addition, we are at risk of further damage due to this process, so it is strongly advised that you bring your Phone to the professional. Just make sure you complete your research, do the right things at first, and don’t put your Phone in the rice bag.
